An important but often confusing area of sharpening is knowing when you're done with one stone and ready for the next finer grit. On coarse stones it is very easy. When you sharpen one side you will notice a burr forming on the opposite side of the edge. This burr is hard to see but is easy to feel. Very carefully feel for the burr by gently running your hand from the spine to the edge. (Do not run your finger along the knife edge from heel to tip, that's only asking for trouble!) A burr is formed when your stone removes material directly at the edge. The burr will move from one side of your knife to another as you alternate sharpening sides. Make sure you have felt the burr jump between both sides before you move on to the next finer stone. That will ensure that you have sharpened both sides effectively. The finer grits are done the same way but the burr is much smaller. On the finest grits you may not be able to notice the burr at all. Testing the knife sharpness will tell you when you're done. (Learn how you can test to see if your knife is sharp.)
if you have regular kitchen knives it will not work- first its to deep and the blade does not stick out, not dinner knives but cooking knives. of all the knives i put in it only 1 was wide enough to stick out. the device does not hold the blades. all the blades tested fell out of it, even a hunting knife, maybe its for 1 type of knife and they are selling it as the must have tool for all.. that said sell something useless for a few bucks that most cant use, they got a few bucks that most will blow off and not worry about a refund.. DONT WASTE YOUR MONEY.
The goal in sharpening a serration is to maintain the ramp of the serration right to the edge. You do not want to create an edge bevel. Therefore we once again recommend the trusty felt pen trick. Paint the serration to be sharpened and follow your process. Evaluate if you are removing all the black. It should not take more than 5-8 strokes to resharpen if your angle was correct. Rotate or spin the sharpener as you go for the most even, consistent sharpening.
If you do not remove enough metal to create a new edge, you will leave some of the dull edge in place. A dull blade (or a blade with dull spots or nicks) will reflect light from the very edge of the blade. A razor sharp knife edge will not show "bright spots" when you hold it blade up under a bright light. You will need to remove enough material from the sides of the bevel so that the edge stops reflecting light.
Clamp-style sharpening tools use a clamp with several holes with predefined angles. The stone is mounted on a rod and is pulled through these holes, so that the angle remains consistent. Another system is the crock stick setup, where two sticks are put into a plastic or wooden base to form a V shape. When the knife is pulled up the V, the angle is held so long as the blade is held perpendicular to the base. Several cutlery manufacturers now offer electric knife sharpeners with multiple stages with at least one grinding stage. These electric sharpeners are typically used in the kitchen but have the ability to sharpen blades such as pocket or tactical knives. The main benefit of using an electric sharpener is speed with many models that can complete the sharpening process in one to two minutes. The disadvantage is that the sharpening angle is fixed so some specialized knives, like a Japanese style Santoku, may need additional attention to sharpen to the ideal angle.
first time buying a sharping stone. i bought this because i wanted to sharpen kitchen knives. you have to practice to get good at it, use a knife you don't care about because you might mess it up. there is some conflicting instructions online on how to use, water or no water. read as much as you can about using stones and practice, practice , practice. look up videos on youtube and internet. i had fun using it, BUY IF YOU WANT TO LEARN here is some stuff i found, they all sound like professionals http://video.about.com/culinaryarts/Sharpen-Knives-With-a-Whetston.htm?rd=1 http://culinaryarts.about.com/od/knivescutlery/ht/whetstone.htm this is a video that says don't use water http://video.about.com/culinaryarts/Sharpen-Knives-With-a-Whetston.htm?rd=1 this is a youtube video that i watched that uses water. *informative http://www.youtube.com/watch?v=KFIg9Cm-nJg
The Chef’s Choice 476 2-Stage Sharpener transforms your weary kitchen, hunting and pocket knives into razor sharp cutting instruments with dependable ease. The sharpener is simple in concept, solid in its fabrication and reliable in the way it goes about its business. The design is also free of right-hand bias which is good news for the lefty chefs out there.
A blade's sharpness may be tested by checking if it "bites"—begins to cut by being drawn across an object without pressure. Specialized sticks exist to check bite, though one can also use a soft ballpoint pen, such as the common white Bic Stic. A thumbnail may be used at the risk of a cut, or the edge of a sheet of paper. For kitchen knives, various vegetables may be used to check bite, notably carrots, tomatoes, or cucumbers. In testing in this way, any nicks are felt as obstacles.
A: That depends almost entirely on how often you use them. If you are a professional chef who uses his or her knives every day then you should hone them every time you use your knives. But honing has its limits and over time your edge is going to become dull no matter what. Therefore your knives will need to be sharpened at least several times a year. Some chefs, in fact, will use a whetstone on an almost daily basis in order to ensure their knives are always razor sharp. Most of us, however, are not professional chefs and may not even touch our kitchen knives for days at a time. In that case, it’s probably a good idea to hone the edge after every couple of uses and have your knives sharpened once a year.