This 600/1,000 grit is my second Unimi knife sharpener, the first is 2,000/6,000 grit and I love them both. Both stones together produce very sharp and well polished knives that reduce the cutting effort and save time in the kitchen. I particularly appreciate that the manufacture printed the grit number on the side of each stone - that helps use the different grits in the proper sequence from the coarser to the finer. The stone comes with a non-slip silicone/rubber base which is very handy.
A: Like cars, knife sharpeners run the gamut from basic to luxury and like cars the price can vary from extremely affordable to more than some people might want to spend. You can get a high quality sharpener that will put your knives through a 2 or 3-stage process which will result in an incredibly sharp edge for less than $20. Or you can buy a mechanical sharpener that will produce a virtually flawless edge for $200+.
You’ve probably seen a number – say 1000 – on the side or top of the Whetstone you just bought and are at a loss as to what it all means, or even worse the person who sold it to you, didn’t know or forgot to mention it. Which ever of these scenarios sounds about right, you are left with a stone and no idea how you should be using it, well let me enlighten you dear reader.
The Japanese sharpening stone whetstone combo is about 9.1 in. in length. It's multi-sided and actually looks like a block of wood. When you use the dark side or the medium grit side (#1000), soak it for about 2-3 minutes. When finished, the ridge on the base which surrounds the stone will fit snugged into it. Even if the base wasn't there the stones friction will stay. Some of the good features of the base is actually the rubber stoppers to hold it on a dry surface. When you learn how to sharpen a pocket knife, doing it on one of these will help.
Start off on the rough grit side of the stone. Check the grit on your stone, or the packaging that came with the stone, to identify which is which. In general, whetstones and diamond stones each have different grits on either side. The rough grit side is used to grind the steel down, while the fine grit side is used to sharpen or hone the knife. The grinding process comes first, so you start on the rough grit side.
I can personally verify that this will get your knives very sharp. I will spare you all the gory details, but the picture is of the instructions the ER sent me home with after stopping the bleeding and patching me up. I have to say, that’s not what I had in mind regarding “Thanksgiving tips”. So: not only will knives slide easily through spinach, but they will go through finger and fingernail like a hot knife through butter after being sharpened by this whetstone. Very clean, straight cut. Impressive, really. Just take it slow and don’t be a moron like me.
The angle on a Buck Knife is set based upon how we feel the knife will be used. Heavy use needs a strong and blunt "V" while skinning or filleting would need a deeper but more vulnerable "V". We tend to grind to 13-16 degrees per side (see illustrations). If you match the existing edge angle and hold the knife against the stone to cut evenly across the edge grind, you will produce an edge with a similar angle.
Technically, the name whetstone can be applied to any form of sharpening stone, regardless of what cutting fluid is typically used with it. However because whet sounds like wet, many hear the word and assume that it refers to a stone that is used wet with water. Actually, water stones, oil stones diamond stones and ceramic stones are all forms of whetstones. So, while all water stones are whetstones, not all whetstones are water stones.