Ceramic sharpening stones were the early replacement for natural stones. Unfortunately there are huge differences in the quality of ceramic stones so be wary. Some are extremely soft and dish out very quickly and at the other end of the spectrum some are so hard they tend to glaze over in a hurry. Ceramic stones need a good soaking for about 10 or more minutes to saturate the pores of the stone prior to use. As all knife steels are different we tend to find that ceramic stones tend to work better with some knives over others. There are no hard and fast rules but we like ceramic for Ao-ko and single edged knives. The Kaiden Ceramic stones are the fastest cutting Japanese stones in Australia and are recommended for advanced users.
Put the pointed, narrow end of the sharpener up against the open end of the gut hook. The narrow, pointed end of the sharpener should face in toward the thickness of the blade, away from the edge of the gut hook. Match the angle of the sharpener to the original edge angle. This will maintain the correct sharpening angle and prevent you from getting cut by the blade tip. Hold the same angle when sharpening each side of the gut hook.
A: Most chefs have their own personal favorite and that’s what it comes down to for just about everybody; personal choice. If you’re the kind who likes to get personally involved in the process you might want to opt for a stone or stick knife sharpener. These will allow you a certain amount of satisfaction knowing it was your expertise that produced the razor sharp edge. Others, however, are quite content to let the machine do the work and that’s fine too.
Push the point you want to sharpen with your fingers. While keeping the angle and pushing the point with your fingers, stroke the blade until it reaches the other edge of the whetstone, then pull the blade back until it reaches the edge of the whetstone. This back and forth is counted as one stroke. Repeat it for about five strokes until you can see or feel some small burrs (edge curvatures) Then move the position of your fingers to where you have not sharpened yet, and repeat this five strokes of sharpening processed from the tip to the base of the blade.