I really liked this whetstone! I had a Smith's pocket sharpener that could get my knife sharp enough for working around in the yard (I have an Opinel no.8). However, in doing a little research I found that the sharpener was only around 600 grit on the finest setting. So this BearMoo 1000/4000 grit looked like the perfect step up, and it turned out to be the perfect stone for me. The pictures are an accurate representation of what you get. The removable rubber base was helpful when switching from one side to the next, and it kept the stone from sliding around. The instructions say that the stone can work with either water or oil, but that water is preferred. It said to leave the stone soaking in water for five minutes, and the stone worked like a champ. I especially liked how the instructions gave you an approximate time of how long the stone takes to sharpen a knife -- it just helped give me an idea that it would take about 15-20 minutes on the 1000 grit side, and then another 10-15 minutes on the 4000 grit. Just turn on a TV show!
I've been using this stone for months and have started to find that, while the fine side does provide a nice sharp edge, the 400gr side is wearing my knives unevenly, which causes me to be unable to finely sharpen the entire length of the blade when moving to the fine side. The logo that is put in the middle of the 400gr side of the knife is causing more material to be removed than the rest of the blade when I'm sweeping across. I even verified this by going straight down the length of the fine side and watching the wear pattern come from the material coming off of the knife onto the stone.
Once the burr is removed, it's time to test the sharpness with paper. Hold a piece of newspaper at about 45°, with a bit of tension, and slash lightly with each point of the blade. If it cuts through easily, your knife's sharp. Warner speedily lacerated his newspaper, but I of course struggled. There is an element of technique involved, he reassured me. 
Our large selection of stones from many well-known manufacturers will allow connoisseurs to find the ideal stone for their needs. Because all manufacturers formulate their stones to emphasize a different mix of qualities, and because these qualities can vary widely between different stones, most woodworkers choose stones from several manufacturers to build up an optimal set of sharpening stones. Then again, once you get to know the characteristics of certain types of stone, you may find one supplier who will provide all the stones you need. Sometimes this can be an advantage. But there is no one size that fits all; each stone must fit your needs and work style. 
×