This wedge ends up short of a "point" to a much larger degree than the picture would indicate. The metal stops short, but then there is black non-slide "tape" applied to one side, and white "slide" tape applied to the other side, which makes the wedge even thicker than it appears in the photo, which means that in practice the end of wedge is even more truncated. So I have a hard time supporting my knives accurately on this wedge while sliding them down into contact with my stones. Prior to buying this wedge I just used a wooden wedge I cut off of a 3" by 3" post using a miter saw, said wedgewhich has a much less truncated end. That wooden wedge unfortunately absorbs water from my Japanese Waterstones. But I will try spraying polyurethane on that wooden wedge to help waterproof itand try again. If that doesn't work I will try to find a 3" by 3" plastic trim board somewhere and cut a wedge off the end of that. Note that you can buy 20 degree plastic wedges, but this is the first one I have found that does 15 degrees (nominal.) Note that Amazon also has the Blue AngleGuide set of wedges, but they are very small https://www.amazon.com/Angle-Guides-Sharpening-Knife-Stone/dp/B01N4QMO7U/ref=sr_1_4?ie=UTF8&qid=1499301705&sr=8-4&keywords=sharpening+angle+guide
I purchased this set together with the 400/1000 grit stone assuming that some of my knives were quite dull and would need work on a coarse grit stone. Premium Whetstone Sharpening Stone 2 Side Grit 400/1000 | Knife Sharpener Waterstone with NonSlip Rubber Base & Flattening Stone. This is my first wetstone. First off I tried to sharpen my Chicago Cutlery boning knife. This knife is nearly thirty years old, has been abused in may ways and was quite dull. It was very difficult for me to get a burr on this blade, which I attribute to poor technique. Next I moved on to my Henckels Professional S paring and chef's knives. The paring knife was moderately sharp and was modestly improved after working over all three grits of stone. It would cut paper but again it was difficult to develop a burr with this blade. Undaunted I switched to the chef's knife. This knife is twenty years old and has never been professionally re-sharpened. I have sharpened it twice with a Lanksey sharpening system which marred the finish but did put a good edge on the blade. Lansky Standard Coarse Sharpening System with Fine Hones. The chef's knife was moderately dull and had several pits visible on the cutting surface. I modified my technique for passing the knife over the stone and worked the chef's knife over the 400 grit stone aggressively and eventually I was able to get a burr to form from the tip of the knife all the way to the handle. From there it was a simple process of reforming the burr on the 1000 grit stone and then finishing on the 6000. After sharpening, the chef's knife easily and cleanly slices a tomato with very light pressure and is in my opinion very sharp. Not sushi knife sharp but more than enough for the chopping and slicing I expect of it. I'm looking forward to going back and working both the boning knife and the paring knife over again. Don't expect a good result from this product the first time you use it. Watch videos on using a wetstone, expect to spend at least twenty minutes per knife at first, and practice forming a burr. If you can form a burr, you will be able to successfully sharpen your knife.
×