Learning sharpening technique requires focus even without worrying about the stone itself. Stones that require frequent flattening, soaking and cleaning, or that take a long time to create an edge can be a source of frustration to some beginning sharpeners. Keep in mind your willingness perform regular maintenance when choosing a starting set of stones.
The height of the spine of your knife off of the stone below it will determine the angle. A typical sharpening angle for a typical chef knife is 19 or 20 degrees per side. For the sake of removing confusing obstacles that could hinder your progress, let’s just sharpen your knife at 20 degrees per side. You can determine exactly how high off the stone that knife should be held by measuring the height of your blade at the heel and then dividing that number by 3 for a 20 deg angle.

Vielsalm Coticule on the other hand generally occurs in much more narrow layers sandwiched between the slate layer and the Belgian Blue layer and thus, it is both less plentiful and more expensive than Belgian Blue stone. Also, Coticule is divided into different grades and sometimes displays blemishes on the surface due to its proximity to the slate layer. Furthermore, it is somewhat harder than Belgium Blue stone and, due to its brittleness, it is bonded to a substrate layer of hard slate prior to sale to prevent the stone from breaking during use.

All rights reserved. WARNING - Under the Liquor Control Reform Act 1998 it is an offence to supply alcohol to a person under the age of 18 years (Penalty Exceeds $17000). It is an offence for a person under the age of 18 years to purchase or receive liquor (Penalty exceeds $700). This web site is operated by Chef’s Armoury. ABN 62 001 477 014. Liquor Licence 36129161.
I purchased this set together with the 400/1000 grit stone assuming that some of my knives were quite dull and would need work on a coarse grit stone. Premium Whetstone Sharpening Stone 2 Side Grit 400/1000 | Knife Sharpener Waterstone with NonSlip Rubber Base & Flattening Stone. This is my first wetstone. First off I tried to sharpen my Chicago Cutlery boning knife. This knife is nearly thirty years old, has been abused in may ways and was quite dull. It was very difficult for me to get a burr on this blade, which I attribute to poor technique. Next I moved on to my Henckels Professional S paring and chef's knives. The paring knife was moderately sharp and was modestly improved after working over all three grits of stone. It would cut paper but again it was difficult to develop a burr with this blade. Undaunted I switched to the chef's knife. This knife is twenty years old and has never been professionally re-sharpened. I have sharpened it twice with a Lanksey sharpening system which marred the finish but did put a good edge on the blade. Lansky Standard Coarse Sharpening System with Fine Hones. The chef's knife was moderately dull and had several pits visible on the cutting surface. I modified my technique for passing the knife over the stone and worked the chef's knife over the 400 grit stone aggressively and eventually I was able to get a burr to form from the tip of the knife all the way to the handle. From there it was a simple process of reforming the burr on the 1000 grit stone and then finishing on the 6000. After sharpening, the chef's knife easily and cleanly slices a tomato with very light pressure and is in my opinion very sharp. Not sushi knife sharp but more than enough for the chopping and slicing I expect of it. I'm looking forward to going back and working both the boning knife and the paring knife over again. Don't expect a good result from this product the first time you use it. Watch videos on using a wetstone, expect to spend at least twenty minutes per knife at first, and practice forming a burr. If you can form a burr, you will be able to successfully sharpen your knife.
×